Customer StoriesDry Ice Cleaning

Dry Ice Blasting Effectively Cleans Casting Molds and Core Boxes

Matt Caminiti
Matt Caminiti
3 min read

TL;DR

The Progress Casting Group needed a faster cleaning method that would not damage their core boxes (particularly the vents and coating) while reducing downtime and improving worker safety. By using dry ice blasting, the foundry was able to clean their low pressure casting molds and core boxes in 10 minutes with one person and save up to $500 per mold.

The Progress Casting Group was looking for a more effective cleaning method for their low pressure casting molds.

The Progress Casting Group in Plymouth, Minnesota specializes in precision die casting and sand castings for the automotive, aerospace and defense industries.

Release agents and residual materials need to be removed from the surface of their casting molds without rounding the corners, which is important for product quality. Rounding of mold edges leads to flash on the parts, shortens the mold life and creates secondary waste and potential eye injuries from atmospheric contaminants.

The refractory coating (releasing agent), the resin spray buildup, sand casting components and core residues on the core boxes and low-pressure casting molds are currently being removed by sand blasting and manually with brushes.

These cleaning methods:

  • Are labor intensive, slow and ineffective
  • Cause extensive downtime
  • Cause damage to equipment (damages vents and destroys urethane on mold)
  • Put workers’ safety at risk

The foundry began to research new cleaning methods that would remove the refractory coatings and other residual material without damaging mold vents. They also wanted to avoid uneven refractory coating, which affects the quality of the final product and speed of production.

Dry ice blasting die casting
Dry ice blasting die casting

The Solution: Dry Ice Blasting

The Progress Casting Group tested a dry ice blasting system and used it to clean their most delicate screen vents at full blast.

The dry ice blasting process is similar in concept to sand or soda blasting, where the respective media is accelerated through a pressurized air stream to clean a surface. However, that is where the similarities end.

Dry ice blasting provides several benefits compared to traditional methods, including that it:

  1. Provides a clean-in-place solution
  2. Is non-abrasive and will not damage sensitive equipment
  3. Is non-conductive
  4. Is environmentally responsible
  5. Does not add secondary waste
  6. Is able to clean in tight spaces

Even at maximum blast aggression, there was no damage to the parts and the molds looked brand new.

Read more about dry ice blasting

Dry ice blasting foundry molds

The Results

“We estimated that it would pay for itself in six months; I know that it took only a month. Every foundry needs to own one.”

1. Reduced cleaning time

Previously, it took two to three workers 3-4 hours to clean one or two molds. Today, it takes one worker 10 minutes to clean a mold while it remains hot and online.

2. Cost savings

The tooling supervisor estimates that they are saving $400 - $500 per mold with a dry ice blasting system.

Approximate annual labor savings: $15,340.

3. Increased productivity

Approximate annual productivity gain: $92,115.

4. Increased profits

Annual net profit (5 mold machines): $106,544.

Rate of Return: 367%.

Learn more about dry ice blasting in foundry

Key Takeaways

  • The Progress Casting Group was cleaning its core boxes with sandblasting and manual brushes, which was slow, labor-intensive, and caused significant downtime
  • Release agents and residual materials must be removed from the surface of their casting molds without rounding the corners to uphold product quality
  • Dry ice blasting cut cleaning time from 3-4 hours with 2-3 workers to 10 minutes with one worker, and saved $400-$500 per mold
Contact

Looking for a strong yet gentle cleaning method for your equipment?

Contact Cold Jet to find the right dry ice blasting solution for you!